Description
Name | Status | Price, $ |
---|---|---|
FLWS-60BSL | ACTIVE | 38 |
General usage conditions - for industrial and commercial usage in conditions of high humidity (0-95%, non-condensing). The device is not intended for domestic use. |
A Water Leakage Detection Sensor can be connected to NetPing server room environmental monitoring units and power distribution units, or another device that supports a “dry contact“ interface type.
You can effectively use it at the following facilities:
- server rooms;
- data centers;
- base transmission stations (cell towers);
- rooms with equipment;
- storehouses;
- guarded objects.
The device exposes two electrode probes (normally open) at the bottom of the sensor. The housing 60 mm in diameter is made of aluminium allow with grooves allowing leaked water to reach the sensor electrodes in case the sensor mounted on a flat surface. The sensor provides relay contact output when the water touch the probes, the relay in the sensor turns on and signals to external alarm circuit.
Two holes on the flange allow mount the sensor on a flat surface (wall, floor) with screws or it can be simply put on the ground. The device is equipped with a LED indicator, which is green when it is powered up and red when the changed conditions trigger the relay to signal an alarm about water leakage.
Please find the information on how to connect the sensor in the “User Manual” for the device you use. For any information on the sensor configuration and functionality, please refer to the Firmware Description document for the device to which you are connecting the sensor.
The sensor comes fitted with a non-detachable cable, which connects to the IO-lines of a device. The cable length can be increased by using Cables 4 extender, 4m, which may be connected in a chain. It is also possible to increase the length of the cable independently using any wire with a cross-section of at least 0.4 square mm. The maximum permissible loop length is 100 meters.