NetPing 4 IP PDU GSM3G R8

Power management and monitoring device over Ethernet for 10″/19″ racks (Switched Monitored IP PDU). 4 Schuko controlled sockets.

switched load power: 3.5 kW, total for all sockets. Up to 1.5 kW per socket;
metal case for installation in a 19′/10′ 1U rack or for mounting on a flat surface;
support for external 1-wire sensors (temperature, humidity, power quality);
built-in 3G GSM modem for SMS control and notification;
built-in ionistor for operation of the warning system in the absence of 220 V;
6 input/output lines for connecting external dry contact sensors and actuators;
2 x 10/100-BASE-TX Ethernet ports;
power consumption monitoring meters on each socket.

Description

Name	Status	Price, $
NetPing 4 IP PDU GSM3G R8	NEW	357

General usage conditions - for industrial and commercial usage in conditions of high humidity (0-95%, non-condensing). The device is not intended for domestic use.

NetPing 4 IP PDU GSM3G R8 is a device of power supply sockets remote management via Ethernet/Internet network with SMS management support. This power distribution unit allows remote turning on, turning off and restarting the equipment by managing 100V … 240V AC, 50/60 Hz sockets, as well as to measure the active power consumption for each outlet.

Modifications

Name	SMS notifications and management	Sockets	Power consumption monitoring meters on each socket
NetPing 4 IP PDU GSM3G R9	3G GSM modem	IEC320-C13	✔
NetPing 4 IP PDU GSM3G R8	3G GSM modem	“Schuko”, Type F	✔
NetPing 4 IP PDU ETH R8	―	“Schuko”, Type F	✔

Applicable solutions:

Remote control of power supply inside ATMs, vending machines, payment terminals and other similar equipment. At the same time, the device can monitor the internal operating conditions of the equipment (for example, ensure that the operating temperature of the bill acceptor does not exceed the permissible range), and signal problems both via the Ethernet network and using SMS commands. If the external power supply disappears, the device will remain in touch via SMS messages and continue to monitor the status of the sensors.
Reload modems, access points, switches, routers, servers and other computer equipment that freezes with no need to access it physically. If a network is unavailable, this operation can be fulfilled via an SMS command.
Remote turning on/turning off additional computer equipment. This allows to save electricity and reduce equipment wear out, because its work is required sometimes or in certain periods of time.
Notifications about power failure at a remote site.
Remotely turn on and off conference call monitors, monitors in a gaming club or internet cafe. Monitors can be controlled both via Ethernet/Internet and using SMS commands.
Remote monitoring of power consumption.
Remote management of air conditioners, ventilation systems and climate control systems. Connected sensors allow current situation surveillance, and a remote 100V … 240V AC, 50/60 Hz sockets management allows turning on a necessary system with no physical presence on an object, including automatic mode.

Device Capabilities

Be notified

Information about the status of sensors is available through the web interface
Email notifications
SMS notifications
Email notifications about events
SNMP v2 trap
SYSLOG notifications

Use web interface from any device

configuration
sensor monitoring
notification and alarm
scheduler
watchdog
NTP-time
firmware update
event log

Power up with remote control and automation

Web interface
URL-encoded commands
SMS commands
SNMP v1 control
LOGIC rules
Scheduler for connected devices
Watchdog over ICMP to react on changed conditions

Enterprise-level reliability

External battery support for uninterrupted operation
Nonvolatile log file
Internal supercapacitor to keep notifications flow up to 6 minutes when all other power sources are lost
Designed and built for uninterruptible operation in 24/7 unattended mode

Support & Warranty

24 month worldwide warranty
Lifetime professional support

Features Included

Remote management of device sockets via the Ethernet/Internet network

Each output socket of NetPing rack power distribution unit can be remotely switched on/switched off/reloaded. Sockets can be managed through a built-in web interface, with the help of any browser or using SNMP commands.

Sockets remote management via SMS messages

Any socket of NetPing rack power distribution unit can be switched on/off or reloaded via SMS message. It allows to control a power supply of a connected device even when the Ethernet/Internet network is down or unavailable.

A watchdog for automatic reloading of an external equipment

If any external device, a router or an access point freezes sometimes, NetPing rack power distribution unit can automatically reload these devices. To do this, it constantly inquires indicated IP addresses by the ping protocol. If it gets no response, it will automatically reload a connected device by turning off and turning on its power supply.

Switching on/off sockets on a schedule

NetPing rack power distribution unit can switch on and off a voltage on its built-in sockets on its own on a weekly schedule, switch on/off a voltage several times a day, use a special schedule for holidays. This may be useful for a daily/weekly forced reboot of external devices or for turning off unused equipment in a certain time of a day.

Specification

Solution
The device is intended for indoor use only	indoor only
A built-in 3G GSM modem for SMS management and notification	Yes
Length of the sensor loop to the device	no more than 50 meter
Form factor and mounting requirement	a metal case for installing into a 10′ rack 1U or mounting on a flat surface
Housed in robust case	made of metal
Static IP	Yes + Mac address
Device control interface	web-interface
Built-in ionistor for the operation of the warning system in the absence of 220 V	Yes
Ability to connect the battery module	Yes
Fanless solution	Yes
Functionalities
Main functionalities
Number of independent power channels managed remotely	4 controllable 100V … 240V AC, 50/60 Hz sockets (JT-G45-120-4P, “Schuko” sockets, Type F)
Number of power sources	1
Short protect circuit	Internal self-healing fuse
Summary output power	3500 W
Watchdog function	Yes
Managing sockets on a schedule	Yes
Individual socket output power	1500 W
Built-in GSM modem SIMCom SIM5300E	Dual-Band WCDMA/HSPA 900/2100MHz, Dual-Band GSM/GPRS/EDGE 900/1800MHz, GPRS multi-slot class 12, EDGE downlink only
Extra functionalities
Remote monitoring of temperature	up to 8 pcs 1-wire (THS) sensors
Remote monitoring of relevant ambient humidity	up to 4 pc 1-wire (HS) sensors
Airflow sensors	up to 6 pcs sensors
Door sensors	up to 6 pcs sensors
Leakage sensors	up to 6 pcs sensors
Motion sensors	up to 6 pcs sensors
Buzzer	6 buzzer
Sensors status information transmission via SNMP protocol	intergations with Zabbix, PRTG Network Monitor, OpenNMS, Nagios, Cacti, The Dude, Monit, and similar monitoring systems
Input-Output lines	6
1-wire sensors support	Yes
Managed NetPing AC/DIN socket	up to 6 pcs sockets
Voltage (electric power) presence and voltage quality monitoring by external sensors NetPing Supply Voltage Sensor 995S2 and NetPing Power Quality Monitoring Sensor 1-wire 910S21	Yes, up to 6 pcs sensors
Built-in web server	Yes
LOGIC support	Yes
Sending notification when the power supply is cut off	Yes
Email notifications	Yes
Get time from NTP	Yes
Internal log	Yes
Configuring logic rules	Yes
SMS notifications	Yes
SMS commands	Yes
SNMP control	Yes, SNMP v1
SNMP trap	Yes, SNMP v1
Syslog support	Yes
URL-encoded commands	Yes
Hardware specification
Connectors
Ethernet port	2 x 10/100 BASE-TX
IO (input-output) lines for connecting external sensors and controlling external devices	6
Control and display
Power LED indicator	Yes
Reset button	Yes
Power supply and parameters
Electric power (main Input)	100 … 250V 50/60 Hz
Power plug	Euro plug, detachable power cord 1.8 meter
Power consumption, by a unit itself	12 W
Radio frequency
Built-in GSM3G modem	Yes
GSM antenna	Antenna ADA-900M-SMA-3,0m (Freq: 900/1800Mhz; a cable RG174 3m; SMA connector; Antenna height 85mm; VSWR<= 1.5; Input resistance 50 Ohm; Maximum power 60W; Gain 3dBi; Vertical polarization)
Dimensions and logistics parameters
Water proof case	No
Device dimensions (W x D x H)	218 x 180 x 44 mm
Package box dimensions (W x D x H)	499 x 253 x 63 mm
Net weight	1025 g
Unit packaged weight (transportation weight)	1325 g
Device packing containment	NetPing 4 IP PDU GSM3G R8 (device), terminals, a power cable, GSM antenna 1 pc, a screwdriver, a user guide, box
Operating conditions
Outdoor / indoor usage restriction	For indoor use only
Ambient air temperature for operation	-30°С … +50°С
Relative humidity	5…95 % (relative humidity has to be not more than 80% while the ambient air temperature is 25°С exact, non-condensing)
Operating atmospheric pressure range	84,0 … 106,7 kPa
Storage conditions
Ambient air temperature for storage	-40°С … +70°С
Storage Relative Humidity	5…95 %
Device reliability
Mean time between failures, MTBF (controllers)	27 000 h
Estimated life expactancy of the product	At least 3 years
Limited manufacturer’s warranty	3 years from production date
Lifetime technical support	Yes

Documentation and files

Firmware

DKSF_5440.2.10.E-2.npu

1 file(s) 504.50 KB

Download

Additional technical files

DKSF_544.2.10_MB.mib

1 file(s) 6.74 KB

Download

DKSF_5440.2.10_OL.oidlib

1 file(s) 7.40 KB

Download

Zabbix 5.0-5.2, 6.0-6.4 NetPing Universal Template

1 file(s) 4.00 KB

Download

How to Buy?

You can purchase all equipment offered at our website for USD directly from us NetPing east Co Ltd. company or from our official partners. All prices indicated on our website are current ones.

To purchase NetPing devices, email please your request to sales@netpingdevice.com. In the email, indicate please the next:

Name and number of models of devices that you want to purchase. Do not forget to indicate sensors and accessories that are necessary for you.
Company name and a name of the recipient of the parcel with equipment.
Complete mailing address for equipment delivery.
Contacts (e-mail and a phone number).

Afterwards, a sales manager will prepare and send you an invoice in USD to pay the order (the details of our bank account and PayPal account are specified on the invoice). The invoice is valid for 10 days, and if you do not pay it within the specified time frame, the invoice will be canceled. To renew the order, you will need to send a repeat request to a sales manager.

Equipment can be sold for 100% prepayment only!

We make discounts to retail customers. Provided by lot (lot - one time buying/shipment):

Lot total amount > 600 USD → 5% discount.
Lot total amount > 1500 USD → 10% discount.
Lot total amount > 3000 USD → special discount.

We deliver equipment to any country of the world for free. Free delivery of devices without batteries is provided by EMS company. Free delivery of devices with batteries is provided by DHL company.

Customers from Russian Federation are welcome to visit our Russian website www.netping.ru and choose there a more convenient method to purchase our goods.

Compatible devices

Cable 4 extender, 4m

Cable extender 1-wire, 10m

Cable extender 1-wire, 2m

Cable extender 1-wire, 5m

FLWS-60BSL

GLS Humidity sensor 1-wire (HS)

NetPing 1-wire hub R912R2

NetPing AC/DIN

NetPing Power Quality Monitoring Sensor 1-wire 910S21

NetPing Supply Voltage Sensor 995S2

PIR DETECTOR (mod.M105-1E)

Temperature sensor 1-wire, (THS)

WA875 Adapter for leakage sensor